P076E code meaning
Shift Solenoid H Intermittent
Powertrain system Generic code P07xx codes Check engine light
What P076E means
Shift solenoid H exists only on transmissions with eight or more solenoids. Ford's 10R80 ends at F, GM's 9- and 10-speeds report clutch pressure valve codes; the only documented user of the H block is the 2017–18 Genesis G80/G90 with shift-by-wire, where it concerns the on/off solenoid of the park lock rather than a shift valve. P076E is an intermittent fault of solenoid H. No manufacturer document available to us uses it; manufacturers usually count such dropouts within their circuit codes. A loose contact at the transmission connector is the most likely cause.
P076E at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 3 hours
- Clears after repairAfter a drive cycle
Symptoms of P076E
- Limp mode or jolt at times, then normal again
- Warning lamp comes and goes
Common causes of P076E
- Most likelyLoose contact or corrosion at the transmission connector
- PossibleChafed harness, dependent on temperature or vibration
- Less likelyCoil with heat-dependent winding fault
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift solenoidTransmission valve bodyTransmission wiringTransmission control module
What each part of P076E means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| 6E | The exact fault in that area. |
What to do next
- Note P076E and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P076E
What does P076E mean?
P076E means "Shift Solenoid H Intermittent". Shift solenoid H exists only on transmissions with eight or more solenoids. It is a generic code, so it means the same on every make.
Is it safe to drive with P076E?
Drive gently and only to a workshop. With P076E the car can go into limp mode (reduced power) to protect itself.
Will P076E fail an emissions test?
Yes, it can. P076E is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P076E to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will P076E clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.