P076C code meaning
Shift Solenoid H Stuck On
Powertrain system Generic code P07xx codes Check engine light
What P076C means
Shift solenoid H exists only on transmissions with eight or more solenoids. Ford's 10R80 ends at F, GM's 9- and 10-speeds report clutch pressure valve codes; the only documented user of the H block is the 2017–18 Genesis G80/G90 with shift-by-wire, where it concerns the on/off solenoid of the park lock rather than a shift valve. P076C means solenoid H is commanded off but stays effective, like P0762 for solenoid C. No manufacturer document available to us uses this code; Hyundai uses only P076A and P076D. The description follows the scheme for the other solenoids.
P076C at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor1.5 to 12 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P076C
- Tie-up or jolt on shifts
- Delayed shifts, engine revs high
- Limp mode
- Check engine light
Common causes of P076C
- Most likelyShift spool or proportional valve sticking in the applied position
- PossibleClutch not releasing (stuck or burnt)
- PossibleSolenoid stuck open or leaking
- Less likelyControl wire shorted to ground (permanently powered)
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift solenoidTransmission valve bodyTransmission wiringTransmission control module
What each part of P076C means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| 6C | The exact fault in that area. |
What to do next
- Note P076C and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P076C
What does P076C mean?
P076C means "Shift Solenoid H Stuck On". Shift solenoid H exists only on transmissions with eight or more solenoids. It is a generic code, so it means the same on every make.
Is it safe to drive with P076C?
Drive gently and only to a workshop. With P076C the car can go into limp mode (reduced power) to protect itself.
Will P076C fail an emissions test?
Yes, it can. P076C is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P076C to fix?
Difficulty: hard. A typical repair takes 1.5 to 12 hours of work. This is a job for a workshop.
Will P076C clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.